无锡市联赢干燥设备有限公司主营:燃煤热风炉|燃油燃气热风炉|直接式燃煤热风炉
当前位置 -> 环亚ag88热风炉知识热水热风炉线磨损量以及水温控制 发布时间:(2018/11/29)关键词:环亚ag88

热水热风炉线磨损量以及水温控制

 

环亚ag88 www.cgfly.cn 热水热风炉在使用成都收账过程中其用户一般情况下可以40度到90度之间进行任意成都找人公司设置其水温,热水热风炉可以直接按照其用户成都收账要求来进行定温以及定时,有效收账向供暖循环系统供热或者是生活用热水。热水热风炉成都找人公司空竹系统是有效的根据其水温度控制循环泵的启停,在使用时其炉水要是有效的达到其设定的上限水温时其热水的循环泵就会停止,要是低于其设定的下限水温时其热水循环泵就会启动。

In the process of using hot water stove, the user can set the water temperature arbitrarily between 40 degrees and 90 degrees. The hot water stove can directly set the temperature and timing according to the user's requirements, effectively heating the heating cycle system or domestic hot water. The diabolo system in hot water stove is an effective way to control the start and stop of circulating pump according to its water temperature. If the boiler water reaches its set upper water temperature effectively, the hot water circulating pump will stop. If the water temperature is lower than the set lower water temperature, the hot water circulating pump will start. 热水热风炉在使用的过程中要是出现其供风量不足或者是阻力过大其主要的原因就是燃料的粒度大小混合,设备中的媒粉占有块煤空隙,然后进入其炉排时被闸门挤压密实,透气性差。

The main reason for the insufficient air supply or excessive resistance of hot-water stove in use is the mixing of fuel particle size. The medium powder in the equipment occupies the void of lump coal. When it enters the grate, the gate is squeezed and compacted, and the permeability is poor.

热水热风炉运行时将一部分的热器受热面有效的布置在比较高烟温的区域,设备中过热器所需要的受热面积大幅度的增大,这样可以有效的减少其工质流过其过热器时增加管子的刚性,设备中过热器采用直接比较大管子。

When the hot air stove is running, part of the heating surface of the heater is effectively arranged in the area of relatively high smoke temperature. The heating area required by the superheater in the equipment is greatly increased, which can effectively reduce the rigidity of the tube when the working substance flows through the superheater. The Superheater in the equipment adopts the larger tube directly.

热水热风炉在使用的过程中其设备的气温特性平稳,设备的炉膛上部可以有效的布置其半辐射式后屏过热器以及辐射式分隔屏过热器,在组成的过程中其每片是由个小屏组成,可以有效的起到增加辐射的传热作用。

In the process of using the hot-water stove, the temperature characteristic of the equipment is stable. The upper part of the furnace can effectively arrange its semi-radiation rear screen superheater and radiation separating screen superheater. In the process of composition, each piece is composed of a small screen, which can effectively play the role of increasing radiation heat transfer.

热水热风炉在运行时其线磨损量应该考虑其摩擦的负荷面积因素,但是其大小会直接随着冲角大小以及被磨削其除量来进行变化,不同的冲角下所测得线磨损量能够进行相互的比较。

The linear wear of hot air stove should consider the load area factor of friction, but its size will change directly with the angle of attack and the dividing amount of grinded hot air stove. The linear wear measured at different angles of attack can be compared with each other.



版权所有@转载请注明:http://www.cgfly.cn/shownews.asp?id=358

本站网址:环亚ag88 来源:联营热风炉  浏览次数:164 
相关阅读:燃气热风炉种类特点以及工作原理 | 烘干热风炉燃煤的好还是燃气的好? | 环亚ag88

版权所有:无锡市联赢干燥设备有限公司主营:环亚ag88    电话:0510-83955910    传真:0510-83051522    技术支持:易商科技